Now more and more customers, when using shaped wire drawing dies, they basically pay attention to their service life. In fact, from the current situation, if you really want to

use these pcd shaped wire drawing dies, everyone must be pay attention to the actual situation of some of their wires. For example, you may pay attention to their wire or 

stainless steel and other metal materials.

In the process of using these shaped wire drawing dies, the calculation is started from ordinary iron wires, and basically has a high record. To some extent, these shaped 

wire drawing dies are actually recorded during the actual processing. That is about five tons, and the wire of about 3.5 should be calculated at about five tons. In addition, 

the high record is 49 tons, and even a good heterosexual wire drawing mold has basically different Diamond mold.

The shaped wire drawing dies are basically in the process of actual use. Their service life is shortened by about 1/3 compared with the life of ordinary iron wires, and they 

have high-quality wire drawing dies, which are basically direct with the processing technology of these production personnel. The related functions of the wire drawing die, 

even the whole profiled wire drawing die have very good flexibility, and they can better grasp the compression ratio and the entire diameter, which must be reasonable during

the actual setting process. The surface should also be very smooth, and even their case should be particularly good. You should also observe their wear to prevent these wear

from being carbonized. In the actual polishing process, you must extend their service life.

No matter for the pcd die blanks or the finished products of pcd wire drawing die, there always have the fit products for your choice.