Diamond Countersinks are the best solutions for countersinking and chamfering composite and abrasive materials, where high wear resistance cutting edge is required. and are achieving amazing savings in countersinking holes into CFRP.

LINKUT PCD Countersinks are built to customers’ specifications, Designed to countersink/chamfer holes at either 100 or 130 degree included angle with a controlled radius between the hole and the chamfer.

This allows for an excellent seal between the rivet and the part, this is due to the rivet not fowling on a sharp edge and therefore seating along the full surface (angle and radius), rather than just on the angle itself.

Excellent for cutting hard or abrasive products such as composites like carbon fibre.

LINKUT PCD Countersinks within the aerospace industry, made with 2, 3 or 4 flutes depending on application and customer specification. Made with the highest quality materials, with a fully ground locating face on the rear of the tool guaranteeing concentricity with your hole.